Answer

s33 is blinking Green /No Internet

The light is blinking green, but it’s not working

Best answer by SURFboard Moderator

If S33 is blinking green make sure that cable signal levels are on acceptable range .

Follow the link below to check on the same :

Do share the values of Downstream and Upstream Channels

i.e the lowest and highest value of power levels /snr / number of channels in Downstream and power levels /number of channels in Upstream

Note: Check if co-axial cable is connected tightly and activated the modem with your Internet Service Provider (ISP)

This topic has been closed for replies.

+41

when its blinking its searching for an upstream/downstream signal. did you activate it through your isp?

did you check the coax or contact the isp?

Current setup: Netgear CM3000-->Netgear RBE973S-->2.5gig tp-link switch, Xfinity 2.4gig/350mbps

+42

If S33 is blinking green make sure that cable signal levels are on acceptable range .

Follow the link below to check on the same :

Do share the values of Downstream and Upstream Channels

i.e the lowest and highest value of power levels /snr / number of channels in Downstream and power levels /number of channels in Upstream

Note: Check if co-axial cable is connected tightly and activated the modem with your Internet Service Provider (ISP)

SURFboard Community Moderator Team

Sign up