Is there anyway I can change the brightness on the front panel LED’s? They light up my whole room at night.
Solved
SB8200 Front Panel LED Brightness Settings?
- The Many
Best answer by BadSamaritan
The SB8200v2 i just installed has an option to turn off the Lights on the configuration page.
- Wi-Fi Warriors
- 3627 replies
Hi EthanHE,
Sorry that you are facing the brightness on your room at night but in sb8200 we don't have the option to change or adjust the brightness on the front panel of the led lights.
If you have any other queries on sb8200 let us know.
+41- Juggernaut
- 2253 replies
I’ve used electric tape before. The blanket is a little bit of a poor choice as it’ll trap heat.
Current setup: Netgear CM3000-->Netgear RBE973S-->2.5gig tp-link switch, Xfinity 2.4gig/350mbps
1 person likes this
- The Many
- 3 replies
- Answer
The SB8200v2 i just installed has an option to turn off the Lights on the configuration page.
1 person likes this
- Wi-Fi Warriors
- 3627 replies
In this case we would suggest you to try the same option on the modem interface after disconnecting the coax cable from the modem to make it work, you can give this a try.
Reply
Most helpful members this week
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.